Protectron terminal entries (Fallout 4)

This page contains the transcript for the generic Protectron control commands used on terminals throughout Fallout 4.

> Protectron Control[]

Note: This is the default header of the command program.

Standard Protectron Control Interface v2.40

This interface should be used by RobCo-licensed technicians only. Improper tampering with Protectron units may lead to permanent injury.

STATUS: Unit(s) Charging/Inactive
CONNECTED: <Token.ValueInt=Connected> Unit(s) Connected to this terminal

Please choose an option:

> Loading Interface...

Note: This is the header of the command program once the Protectron(s) is active.

Standard Protectron Control Interface v2.40

This interface should be used by RobCo-licensed technicians only. Improper tampering with Protectron units may lead to permanent injury.

STATUS: Unit(s) Patrolling/Active
CONNECTED: <Token.ValueInt=Connected> Unit(s) Connected to this terminal

Please choose an option:

> Loading Interface...

Note: This is the header of the command program after activating the Protectron(s) but before they leave the pod.

Standard Protectron Control Interface v2.40

This interface should be used by RobCo-licensed technicians only. Improper tampering with Protectron units may lead to permanent injury.

STATUS: Unit(s) BUSY
CONNECTED: <Token.ValueInt=Connected> Unit(s) Connected to this terminal

Please choose an option:

> Loading Interface...

Note: This header of the command program is displayed once the Protectron(s) is no longer within the Protectron pod.

! ERROR ! !
Protectron unit absent or damaged!

> Loading Interface...

Activate Unit(s)[]

Note: This is the default command of the command program.

...Accessing pod...
...Initializing unit...
...Loading assigned subroutines...

Please advise any personnel standing near charge pod to make way.

> Exiting Charge Pod

Shut-Down Unit(s)[]

Note: This command is available once the Protectron(s) are activated.

...Accessing pod...
...Pinging Protectron Unit...
...Broadcasting shut-down signal...

Please ensure that Charge Pod is unobstructed.

> Returning to Charge Pod